Datalogic DS6300-100-011 Instalační manuál stáhnout pdf (Strana 75)

TYPICAL LAYOUTS

NOTE

For some DS6300 Lonworks Network layouts, power is propagated through

the 9-pin scanner connectors. A specific jumper setting is required in CBXs

to pass scanner power to the presence sensor, encoder, etc.

7.1.1 Small Synchronized Network

When building a small local Lonworks network (less than 10 scanners), the DS6300 master

reader must be connected to a local host computer or a CBX connection box by means of a

cable connected to the 25/26-pin D-sub male connector.

The master reader connects to the first slave reader of the system through the local

Lonworks 9-pin female connector. For Master/Slave models, the local Lonworks 9-pin male

connector must be properly terminated by inserting the BT-6000 Lonworks terminator.

Fieldbus models (Ethernet, DeviceNet, or Profibus), are internally terminated.

The slave readers are connected together through the local Lonworks connectors. Only the

9-pin female connector of the last slave reader must be terminated by the BT-6000 Lonworks

terminator.

The presence sensor is connected and powered through the CBX by the scanner and is

unique to the system. There is only a single reading phase and a single message from the

master reader to the Local Host. The On-Line operating mode is used for this layout.

Figure 83 – Small Synchronized Network with 2 Readers

PWR-120

Local Host

CBX100**

Maste

Slave 1

CAB-Sxx

CAB-610x

P.S.*

BT-6000

I/O, AUX

BT-6000

* P.S. (Presence Sensor) connected to Input 1 (External Trigger/PS) input.

** CBX100 jumper set to accept scanner power.

CAB-63xx

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 128 129

Žádné komentáře

Datalogic DS6300-100-011 Instalační manuál Strana 75