Datalogic QuickScanQS6500BT Specifikace stáhnout pdf (Strana 264)

Symbologies

6-176 QuickScan

QS6500/QS6500 BT

Code 16K — continued

Code 16K Data Group Characters

Once you’ve pre-set your desired Data Group Characters

using the Data

Group Characters

feature found in Chapter 5, Data Editing, you can choose

to output up to two of those pre-sets whenever a Code 16K bar code is

scanned.

To set this feature:

1. Determine which Data Group pre-set(s) to output. You can select

up to two from the following:

Data Group 1 * Data Group 2 * Data Group 3 * Data Group 4

For example, your choice might be Data Group 2 only; Data

Groups 1 and 3; Data Groups 3 and 4; or no Data Groups.

2. Scan the START bar code to place the imager in Programming

Mode.

3. Scan the SET CODE 16KDATA GROUP CHARACTERS bar

code.

4. Turn to

Appendix B, Alpha-Numeric Pad and scan the digits repre-

senting the Data Group designation(s) chosen in the first step

above. A digit of value zero (0) selects “no group.” For example,

scanning 3 and 0 would output only the character(s) set for Data

Group 3 whenever a Code 16K bar code was scanned. Scanning

digits 1 and 2 would output both Data Groups 2 and 3. To select

no Data Groups at all, scan 0, then 0 again.

5. Scan the SET bar code to accept the digits scanned.

6. Scan the END bar code to exit Programming Mode.

1. In that chapter, you can select which character(s) and position(s) to place Data Characters

within scanned data output.

NOTE

The options in this section set Data Group Characters

for the Code 16K symbology ONLY. If you wish to enable

this feature for additional symbologies, turn to the

options in the section specific to the other symbol-

ogy(s).

1 2 ... 259 260 261 262 263 264 265 266 267 268 269 ... 335 336

Žádné komentáře

Datalogic QuickScanQS6500BT Specifikace Strana 264