Datalogic A30 Manuál s instrukcemi stáhnout pdf (Strana 17)

EXTERNAL ILLUMINATORS

OUTPUT CONNECTIONS USING EXTERNAL POWER

Figure 20 - Output Open Emitter Using External Power

Figure 21 - Output Open Collector Using External Power

EXTERNAL ILLUMINATORS

If an External Illuminator (strobe light) is used, it can be powered from the CBX connection box.

It must be connected to the Vdc and GND terminal clamps. The strobe signal connection is

shared with Output 3. If a non-zero value is defined for the Strobe Pulse Length value (in VPM –

Impact – General), the strobe is active. If the value is zero, Output 3 is active.

CAUTION

Power is available directly to the strobe, independently from the Power

Supply Switch inside the CBX.

Configure the Strobe Signal in the VPM software. Refer to the Camera Setup tab section of the

Impact Reference Guide.

Figure 22 – External Illuminator Connections

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Žádné komentáře

Datalogic A30 Manuál s instrukcemi Strana 17