Datalogic DS2200 Instalační manuál stáhnout pdf (Strana 22)

DS2200

2.5 TYPICAL LAYOUTS

The following typical layouts refer to system hardware configurations. Dotted lines in

the figures refer to optional hardware configurations within the particular layout.

These layouts also require the correct setup of the software configuration

parameters. Complete software configuration procedures can be found in the Guide

To Rapid Configuration in the WinHost Help On Line.

2.5.1 Point-to-Point

In this layout data is transmitted to the Host on the RS232 Auxiliary serial interface.

The Local Echo communication mode must be enabled (default) see the WinHost

Help On Line.

When On-Line Operating mode is used, the scanner is activated by an External

Trigger (photoelectric sensor) when the object enters its reading zone.

Auxiliary serial interface

External Trigger (for On-Line mode

)

Host

DS2200

Figure 13 - Point to Point layout

2.5.2 RS485 Master/Slave

The RS485 Master/Slave connection is used to collect data from several scanners to

build a multi-point or a multi-sided reading system; there can be one Master and up

to 5 Slaves connected together.

The Slave scanners are connected together using the RS485 half-duplex main serial

interface. Every Slave scanner must have a multidrop address in the range 0-4.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 32 33

Žádné komentáře

Datalogic DS2200 Instalační manuál Strana 22