Datalogic Matrix 200 Manuál s instrukcemi stáhnout pdf (Strana 17)

RAPID CONFIGURATION

3. Refer to the Reading Features table in chp. 7 to determine the distance your reader

should be positioned at.

NOTE

Rapid Configuration of the Matrix 200™ reader can be made either through

the X-PRESS™ interface (steps 3-4) which requires no PC connection, or by

using the VisiSet™ Autolearning Wizard (steps 5-6). Select the procedure

according to your needs.

STEP 3 – AIM THE READER

Matrix 200™ provides a built-in aiming system to aid reader positioning. The aiming system

is accessed through the X-PRESS™ Interface.

1. Power the reader on. During the reader startup (reset or restart phase), all the LEDs blink

for one second. On the connector side of the reader near the cable, the “POWER ON”

LED (blue) indicates the reader is correctly powered.

2. Enter the Aim/Locate function by pressing and holding the X-PRESS™ push button until

the Aim LED is on.

3. Release the button to enter the Aim function. The blue ring turns on.

4. Place the application specific code in front of the reader at the reading distance indicated

for your model in the Reading Features table, centering it in the blue ring.

FOV

Figure 7 – Aim Function Using The Blue Ring

green

yellow

red

Figure 8 – X-PRESS™ Interface: Aim Function

5. Exit the Aim function by pressing the X-PRESS™ push button once. The blue ring turns

off.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 120 121

Žádné komentáře

Datalogic Matrix 200 Manuál s instrukcemi Strana 17