Datalogic Memor Uživatelský manuál stáhnout pdf (Strana 49)

USE AND FUNCTIONING

3.3 DATA CAPTURE

To capture data first of all select the barcode icon on the bottom-right side of the

display and tap the 'Capture' menu item then proceed with the following

directions.

To configure and enable data capture parameters refer to par. 3.6.

3.3.1 Laser Data Capture

To scan barcodes, point the Datalogic Memor™ laser model onto the code from

a distance within the reading range while pressing the SCAN key.

The lighted band emitted by the laser must completely intercept the barcode as

shown in the figure below.

If the scan has taken place correctly:

- the Good Read LED gets constant Green for a configurable time;

- if enabled, the GoodReadSound emits an acoustic signal;

- if enabled, the GreenSpot projects a green spot onto the bar code image.

NOTE

Remove the protective film cover over the Laser Output

Window before use.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 116 117

Žádné komentáře

Datalogic Memor Uživatelský manuál Strana 49