Datalogic Controller SC6000 Uživatelský manuál stáhnout pdf (Strana 21)

PROGRAMMING STRINGS

The 'Restore Default Configuration' programming command must have the following

format:

SD<space>DEFNUM<CR><LF>

Where:

 SD:

Restore Default configuration command

 DEFNUM:

Default configuration number. The only possible value is currently:

0 = Factory Default

After entering this command, the device responds with the proper reply message and then

waits for one or more programming strings.

If the programming is correct, the device updates the configuration and confirms with the

following message:

Y<space>DEFNUM<CR><LF>

Where:

 DEFNUM:

Default

If programming contents are wrong (i.e. a typing error in the file) or due to a transmission

error, the device replies with the following message:

N<space>ERRCODE<CR><LF>

Where:

 ERRCODE:

Error Code (signed DEC value)

For information on Error Codes see the "Error Codes Table" in the Appendix.

CAUTION

This programming command will be applied to all Configuration and

Environmental parameters. Refer to the Genius



Help On Line of the

selected device for further details.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 79 80

Žádné komentáře

Datalogic Controller SC6000 Uživatelský manuál Strana 21