Datalogic DL Cordless Card DLCC Uživatelský manuál stáhnout pdf (Strana 44)

DL TCL™

When configuring the radio, the "Out of Range" option (set [AUTO]) allows DL TCL™

to automatically signal if during data transmission a terminal is out of the area

covered by the Access Point. For all terminals this condition will be signaled by the

LED activation, while for Rhino™ terminal the signal is emitted by the beeper. If set

to [ON], it is possible to verify this condition only if trying to transmit from the terminal.

In all these cases, the following message is displayed:

OUT OF RANGE

Retry? ( Y/N )

Radio

Card Model

Settings

IEEE 802.11b Wi-Fi

Cisco 340/350

- SSID = sets the Service Set Identifier of the specific

wireless network

- Power Options = specifies the Power Save Mode,

where CAM corresponds to Constant Awake Mode,

PSP to Power Save Mode and FASTPSP to Fast Power

Save Mode

IEEE 802.11b Wi-Fi

Lucent/ARTEM

W-Card 11 ComCard 11

- Wireless Network Name = sets the Service Set

Identifier of a specific wireless network. When this

parameter is omitted, or is specified as an empty string

or as “ANY”, the station may connect to any network

- Card Power Management = enables or disables the

terminal use of the Power Management. Specifying 2

enables Enhanced Power Management, specifying 1

enables the Standard Power Management, while

specifying 3 disables the Power Management

IEEE 802.11b Wi-Fi

Symbol Spectrum

24 High Rate

- ESS ID = sets the Service Set Identifier of a specific

wireless network

- Performance Index = selects the power saving mode by

inserting a number between 0 and 5, where 0 sets the

consumption of most power at maximum speed, and 5

sets the consumption of least power at minimum speed.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 61 62

Žádné komentáře

Datalogic DL Cordless Card DLCC Uživatelský manuál Strana 44