Datalogic POWERSCAN PBT7100 guide Manuál s instrukcemi stáhnout pdf (Strana 11)

About This Manual

Product Reference Guide 1-3

Base Station Connection and Routing —

Fully insert the Power Cable and

Interface (I/F) Cable connectors into their respective ports in the under-

side of the Base Station (see

Figure 1-1). Alternatively, you can either loop

the cables around the routing clips and back through the routing chan-

nel to the front of the Base Station as shown, or the cables can be fed

directly out the back of the Base Station via the routing clips.

Figure 1-1

. Connecting the Base Station

Host Connection —

The interface type was specified at the time your scan-

ner was ordered, however you should verify before connection that the

scanner’s cable type is compatible with your host equipment. Most con-

nections plug directly into the host device as shown in

Figure 1-2. Key-

board Wedge interface cables have a ‘Y’ connection where its female end

mates with the male end of the cable from the keyboard and the remain-

ing end at the keyboard port on the terminal/PC.

Bottom of Base Station

Routing

Clips

Base

Station

I/F Cable

Power Cable

Routing

Channel

Power Cable

Adapter

I/F

Cable

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 271 272

Žádné komentáře

Datalogic POWERSCAN PBT7100 guide Manuál s instrukcemi Strana 11