Datalogic POWERSCAN PBT7100 guide Manuál s instrukcemi stáhnout pdf (Strana 116)

Bluetooth Features

5-16 PowerScan® 7000BT SRI

BT Leash Beep

This feature enables or disables the Leash Beep, which occurs upon dis-

connect. When enabled, the scanner will beep three times per second for

the number of seconds defined in this setting to notify if a linked scanner

is leaving the immediate vicinity of the Base Station

. This is especially

useful in instances where a scanner might inadvertently have been placed

in a bag or cart. A setting of 000 disables the Leash Beep.

1. The Base Station does not include a beeper. Only the scanner will beep to indicate.

START/END

MODE BAR CODE

Sets the BT Leash Beep using a hex value from 000

to 255. Settings are in one second increments.

To configure this feature, scan the “START/END” bar

code above to place the unit in Programming Mode,

then the “Set BT Leash Beep,” followed by the three

characters (zero padded) from the Alphanumeric

table in

Appendix C, Alpha-Numeric Pad repre-

senting your setting. Exit programming mode by

scanning the “START/END” bar code above.

SETTINGS EXAMPLES:

000 = Disable Leash Beep 015 = 15 seconds

042 = 42 seconds 255 = 4 min 15 sec

DEFAULT SETTING FOR THIS FEATURE:

000 (Disabled)

Set BT

Leash Beep

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 271 272

Žádné komentáře

Datalogic POWERSCAN PBT7100 guide Manuál s instrukcemi Strana 116